Innova IN-8012, Инструкция и руководство по безопасности, Страница: 5 / 28

MU8012-002ANG Rev2 2016
P. 4
m) A person who has not read this instruction and safety manual, has not been trained in using the
XTIRPA

System and does not understand all operation, safety, maintenance, servicing and storage
instructions contained in this instruction and safety manual and in any other recommendations provided
by the manufacturer or its certified trainers is not qualified to operate the
XTIRPA

System and does it
at their sole risk, therefore waiving any and all claims, rights and recourses against the manufacturer and
derived therefrom.
n) Make sure to conform to relative demands regarding anchoring devices (E.g.: floor adapter, wall
adapter, etc.) or ensure that the chosen structure that will be used has an anchoring point, and keep in
mind minimal required resistance, equivalency and position.
o) The maximum force that can be applied by the system to the structure is a vertical force of 22kN
(5000 lbf) according to CSA, ANSI, OSHA or 12kN according to EN362, EN795 CE from the anchor
when the system is placed.
p) A rescue plan shall be put in place in order to account for all likely emergencies that could occur while
working.
WARNING: Anchor ing devices must be installed only by competent persons or or ganizations.
WARNING: Any modification or addition to the equipment cannot be done without the pr ior
written consent of the manufacturer, and any repairs must be undertaken in accordance with the manu-
facturer’s procedures.
WARNING: This equipment (system) is reserved for the use of one person at a time.
WARNING: It is important to place the XTIRPA™ System on a hard and level surface. Do not use the
XTIRPA™ System on a soft surface, including, but not limited to, sand, grass, gravel and rocks. If
you have any questions about use or maintenance or whether the XTIRPA™ System is appropriate for
your job, please contact the Manufacturer PSP INNOVA INC.
WARNING: The system must be appropriately checked, for example, by calculations or tests.
WARNING: The use of a base, structural anchor or fastener, if one exists, must be taken into account
when calculating the amount of force supported by the anchor during strength and integrity testing.
WARNING: For safety r easons, make sur e when using the anti-drop system that you have enough
space under the user, so as to avoid injury. If a fall occurs, there should be enough space to avoid a colli-
sion with the ground or any obstacle. See the diagram in Section 8 for calculating this distance.