Innova Srl
Page 18
N420355A_Manuale-SLC 2022_EN_Rev 03.docx
5
ELECTRICAL CONNECTIONS
5.1
GENERALITY
- Before starting any operation to make the electrical connection make sure that the unit is not electrically powered
- Make the necessary electrical connections by consulting only the wiring diagram attached to this manual.
- Install a suitable breaking device and differential protection for the exclusive service of the unit.
- IS it is essential that the unit is connected to an earth socket.
- Check that the electrical components chosen for the installation (main switch, circuit breakers, cable section and terminals) are suitable for the
electrical power of the installed unit and that they take into account the starting currents of the compressor as well as the maximum load that can
be reached. The relative data are indicated on the attached wiring diagram and on the unit identification plate
- IS It is forbidden to enter the unit with electric cables unless specified in this booklet.
- Use cables and electrical conductors with adequate sections and in compliance with the regulations in force in the various countries.
- Absolutely avoid running electrical cables in direct contact with pipes or components inside the unit
- After the first few moments of operation, check the tightening of the screws of the power supply terminals
Power line sizing table:
400
600
800
1000
1200
Diet
V / Ph / Hz
230/1/50
Max absorbed power
kW
0.75
0.095
0.17
0.23
0.26
Max absorbed current
TO
0.7
1.3
1.3
1.5
1.9
5.2
POSITIONING AND CONNECTION PROCEDURES
On the side of the unit there is the electrical box for
the electrical connections, while inside the box
there are the cable clamps and the screws supplied.
Electrical connections