44
InnoMedia, Inc
.
All Right Reserved
FS write: OK.
Voice Volume Control
Set Voice Volume for Each Channel (Ga)
Use the "
Ga
" command to change your SIP Device’s voice volume. You may adjust the
volume downwards by entering the absolute value in dB. SIP Device only supports
negative dB values. For example, if you’d like to adjust the volume to –3 dB, enter "3".
The maximum value is "0" dB.
SAMPLE:
Ga
Current RX volume level for channel 1 = 0 dB
Current TX volume level for channel 1 = 0 dB
Current RX volume level for channel 2 = 0 dB
Current TX volume level for channel 2 = 0 dB
Please enter the channel No. for volume control (1-2) or
press e to exit:
1
Please enter RX volume level (0 ~ 18) or press <CR> to exit:
3
Please enter TX volume level (0 ~ 18) or press <CR> to exit:
3
Volume control succeeds!
Current RX volume level for channel 1 = -3 dB
Current TX volume level for channel 1 = -3 dB
Current RX volume level for channel 2 = 0 dB
Current TX volume level for channel 2 = 0 dB
Please enter the channel No. for volume control (1-2) or
press e to exit:
e
Do you want to store the changes permanently? [y/n]
y
Writing to Flash, please wait...
Writing to Flash is done successfully.
Information about the System
Displaying the current setting of digitmap (Id)
Use the "
Id
" command to view the current digit map stored in the SIP Device.
SAMPLE:
Id
DisplayVoIPDigitmap:
(Profile 1) ***1|[#*][6-9]X|1XXXXXXXXXX|[2-9]XXXXXX|0[0-9][0-
