External input connection
Charlie-C has an input connector for a potential free control signal from a 3rd party unit. When signal occurs
in the input, Charlie-C will limit the maximum charging current to 8A. When the signal returns to the normal
state, the maximum charging current returns to the predefined value.
1. Connect the potential free output of the control unit to connector pins CC+ and CC- .
2. Set the DIP switch of the 3rd party control units to Normally Open or Normally Closed, according to the following table.
DIP S2
contact
max current
note
According to the current setting
of the DIP S2 switch (10-32A)
8A
Use this setting if no
external control is used
According to the current setting
of the DIP S2 switch (10-32A)
8A
Use this setting if
external control is used
Closing the charging station cover
After the wiring installation is done, install the charging station cover.
1. Push the cover onto the back part of the charging station. Make sure the clips on the inside of the top part of the cover are
inserted properly into the holes on the back part of the unit.
2. Install the screws to the bottom of the charging station cover.
3. Install the screw to the top of the charging station cover
1
7
