Inner Range Integriti Elite, Руководство пользователя, Страница: 18 / 32

16
Integriti Integriti
Integriti Integriti Integriti
LCD Terminal Keypads User Manual.
Area Walk Testing. See note at top of page 14.
This option allows specified Zone Inputs to be tested prior to turning the Area ON.
Testing simply involves activating the devices (usually detectors) and then allowing
them to return to their normal state. e.g. Walk past movement detectors, open and
close doors, press then release panic buttons, etc.
    


 

After the initial test to check that all Zones are
Sealed, the Walk Test commences. The display
will update with a beep every few seconds to
show any Zones that have not been tested.
The following key functions are available while
this display is shown, and may need to be used if
any device fails to operate or cannot be tested:
To abort the Walk Test or Isolate one or more
Inputs that cannot be tested, and turn the Area ON,
press the <OK> key to Isolate an Input while its
name is being displayed until the “All Inputs
Sealed” message is displayed.
CAUTION: Inputs Isolated in this operation will
not be monitored for this arming period.
To abort the Walk Test without turning the Area
ON, press the <END> key.
To manually advance to the next untested Zone,
press any other key.
When all the Zones have been tested and there are
no faults, the “All Inputs Sealed” message is
displayed briefly and the normal Arming
procedure will continue.
The walk test will only run for a limited time. The
time is programmed by the Installer.
If the walk test is not completed within the
allowed time, the test will be aborted. The
message shown opposite will be displayed and the
Area will NOT be armed.
 
  

   
 
 



  