Inner Range Integriti Elite, Руководство пользователя, Страница: 16 / 32

14
Integriti Integriti
Integriti Integriti Integriti
LCD Terminal Keypads User Manual.
Turning Area/s ON.
Logon to the Terminal as described earlier.
(PIN code + <OK>)
After the greeting (if enabled), the display will
show the Area Status as before. If you are allowed
to control more than one Area, the DISPLAY
MODE can be changed and AREA/S SELECTED
as described in “Turning Area/s OFF”.
At the “Press ON” prompt, turn the displayed Area
(or Area List) ON by pressing the <ON> key.
After the <ON> key is pressed, the system will
test the state of all the inputs allocated to the Area
to ensure that they are in the Sealed condition and
the Area is ready to be turned ON.
THEN:
If all Zones programmed to be tested are Sealed,
the Area will turn ON and the display will show:
a) The exit delay countdown if the “Exit display”
option has been enabled by the Installer and the
Area has an exit timer. Upon expiry, the display
will return to the default display.
OR
b) The default display if there is no exit timer or
the “exit display” option has been disabled by the
Installer.
    


 

 
 



  
Display briefly shows:
- ,
NOTE: Some systems have the Pre-Arm “Walk Test” feature enabled. If so, the
procedure below is followed except that after the initial Input Seal test, the system
then enters Walk Test mode. Refer to “Area Walk Testing” on the following page.
 
 

 
  
See “Quick Arm/Disarm” under “Turning Area/s OFF” for additional information.