Inmes FF-325 PLUS, Руководство по эксплуатации

Страница: 21 / 62

INMES Industrial Ltda – Sliding table saw FF-325 Plus 19
6.3.2 Working with the table (Pic. 6.3.2)
Lock the extension table. Place the cutting piece
against the side of the ruler. Push the piece forward
against the blade
- For your safety, use the plastic pusher.
(Pic. 6.3.2)
6.4 Proper use of the machine (Pic. 6.4)
- Frequently clean the metal body and saw teeth with appropriate liquids by leaving the blade in a bath, then
clean it with a non-metallic brush.
- Regarding the part of the teeth, at least two to three teeth must cut at the same time A, if only one cut at a
time B, you will not have the desired cut quality. Whenever possible, it is also recommended to lift the
blade until the entire cutting edge reaches the full thickness of the cutting part.
-First make sure there is no excessive vibration in
the machine.
-Do not attempt to remove the material to be cut
while the cut is not yet complete.
- Continue cutting at a constant and uniform speed.
-The saw feed (especially where there are knots)
should not be fast (the cutting speed must be
according to the thickness of the workpiece).
-Do not let the piece stop between the blade and the
ruler.
- Avoid contact of the saw teeth with metallic
objects.
- Whenever necessary sharpen the blade.
(Pic. 6.4)