Inmes FF-325 PLUS, Руководство по эксплуатации

Страница: 25 / 62

INMES Industrial Ltda – Sliding table saw FF-325 Plus 23
Problem Possible cause Solution
Serra stopped, does not
turn on anymore.
Overload locking the engine.
Allow the motor to cool and turn the
breaker on again.
Saw off the plug. Check all connections.
Disarmed breaker. Turn on the circuit breaker.
Damaged wire. Replace the wire.
Does not make exact cuts
at 45 ° or 90 °.
Misfits.
Check the blade with the square and
make appropriate adjustments to the
stops.
Marker clock unregulated.
Check the blade with the square and
adjust the marker.
The piece bends the blade
during cutting.
Misaligned stop with blade. Adjust the stop
Uneven wood. Replace the part to be cut.
Too much blade feed speed. Slow down.
Blade knife not aligned. Align the knife with the blade.
Saw makes unsatisfactory
cuts.
Blind blade. Sharpen or replace the blade.
Back mounted blade. Turn the blade over.
Resin or glue on the saw. Remove the saw and clean it.
Incorrect blade for cutting. Replace the blade with a new one.
Glue or resin on the table. Clear the table.
Blade does not reach
constant speed.
Incorrect dimension extension wire.
Replace the wire with a suitable
one.
low voltage Contact your local power company.
Motor wiring for wrong voltage. Check motor wiring box.
Saw vibrates a lot.
Machine in an uneven place. Reposition the machine.
Damaged blade. Replace the blade.
Damaged Belt. Replace the belt.
Crooked pulley. Replace pulley.
Improper motor mounting. Check and adjust the engine.
Clearance in the height adjustment
mechanism.
Adjust the height adjustment
mechanism.
Loose machine structure. Tighten the machine frame.
Ruler holds the guide.
Guide or extension is not mounted
correctly.
Reassemble the guide, referencing
the stop.
Guide or ruler not adjusted correctly. Adjust the guides to the stop.
Material bounces when in
contact with blade.
Misaligned ruler. Align the ruler to the blade.
Knife misaligned with blade. Align the knife with the blade.
Cut made without ruler support. Install and use the ruler.
Saw knife out of place.
Install and use the knife (with
collector).
Blind blade. Replace the blade.
Drop the piece before it passes the
blade.
Push the material all the way past
the blade.
Knife plate is not sharp. Replace or sharpen the blade knife.
Blade has no free height
and tilt adjustment.
Saw lifting mechanism too tight. Adjust the mechanism and its shaft.
Dust and wood chips on the saw lift
mechanism.
Clean and grease the settings.