INIM snartliving, Руководство пользователя

Страница: 19 / 44

User’s Manual
Shortcuts 19
3-2
Shortcut with code
Besides the keypad shortcuts provided by keys
, each user code can have as many as 22
customized (personal) shortcuts.
Users can access their code-shortcuts by entering their PINs and pressing
(refer to paragraph 2-5-1 Accessing the User Menu ). Each code can be
programmed to manage:
• Up to 12 shortcuts activated by keys to and identified by
explicit icons.
• Up to 10 shortcuts activated by keys to . If a code is
enabled to operate the system over-the-phone, these shortcuts will also
be available on the telephone number-keys.
Entry of a code associated with shortcut no.9: at a JOY/MAX keypad,
prompts the voice announcement of all the shortcuts assigned to the
number keys.
To activate a shortcut at a keypad, work though the following steps.
1. Type in your code then press .
2. Access the User Menu, using the method described in paragraph 2-5-
1 Accessing the User Menu , at point 2.
3. Press the key from to which corresponds to the shortcut
icon, or press the key from to which is assigned directly
to the shortcut.
To activate a shortcut over-the-phone:
1. Establish communication with the control panel.
2. Type in your code followed by “#”.
3. Press the number key which corresponds to the required shortcut.
3-3
Key and Reader shortcuts
3-3-1
nBy/S and nBy/X Reader
shortcuts
Hold a valid key in the vicinity of the reader, a series of visual signals on
the reader LEDs will indicate the various shortcuts.
When the required shortcut is indicated, remove the key to activate the
corresponding shortcut action.
The visual signals on the Reader LEDs are as follows (refer to
Table 6:
Reader LEDs with key at reader ).
1. Red LED on for 3 seconds - shortcut associated with the red LED
of the reader or first shortcut of the key
2. Blue LED on for 3 seconds - shortcut associated with the blue LED
of the reader or second shortcut of the key
3. Green LED on for 3 seconds - shortcut associated with the green
LED of the reader or third shortcut of the key
4. Yellow LED on for 3 seconds - shortcut associated with the yellow
LED of the reader or fourth shortcut of the key
5. All LEDs on for 3 seconds - first shortcut associated with the user
key
6. All LEDs off for 3 seconds - disarm all the partitions.
7. If the key is not removed, the reader will run through the entire
sequence again starting from the red LED. Selection of the desired
shortcut (indicated by a specific LED) will not occur until the key is
removed.
If, during this phase, any of the partition are armed, the LED sequence will
start at point 6.