12
System Parameters
Fire detection and extinguishant system
The "Parameters" section provides:
•
Get date and time
, check box that allows you to set and
update the date and time of the control panel from the
Cloud, in accordance with the time zone selected by
pressing the dedicated button and setting the area and
zone
•
Ethernet
, check box that enables the Ethernet channel to
communicate with the cloud
•
Cloud failure delay
, check box that allows you to set the
time interval, indicated below, after which, in the event of
lack of communication with the Cloud, the relative fault
will be reported
The
Esc
and
Set
buttons will allow you to exit the section
without changing the programming or saving it.
3.2.1 Registration of the control panel to Inim Cloud
The registration of a control panel is an operation that allows its accessibility to all Inim Cloud service users. It is therefore
necessary that the registration is carried out first by the installer, registered with the Inim Cloud service, so that at a later
time users can add the already registered control panel to their own account.
1.
Access control panel programming (
paragraph 2.2
) and then tap the "Cloud" icon in the control panel
configuration screen.
2.
Access the “Enroll” section
3.
Enter the 8-digit ID-installer number contained in the confirmation email received during registration to the Cloud as
an installer.
In this section you can activate the "Installer Property" option. If activated, the installer reserves the management of
accesses to the system by the Cloud. If not activated, this property is assigned to the first user enrolled.
4.
Press the
Enroll
button. The control panel carries out the registration of the the control panel on the Cloud and the
display will show the "WAIT" message.
If the control panel date/time differs by more than 15 minutes from the exact date/time, the registration process may
result negative .
5.
The display will show the result of the procedure using one of the following messages:
• “Account created!”: the control panel has been successfully registered to the Cloud
• “Communicat.Error”: generic communication error.
The possible causes may be:
- no Internet connection
- date of manufacture of the control panel is earlier than dd/mm/yyyy
- date/time of the control panel is different, ahead or behind the exact date/time by more than 15 minutes
• “Already enrolled”: the control panel is already registered to Cloud
• “Panel notEnabled”: the control panel cannot be registered to Cloud.
3.3
Configuring the Ethernet network
If an Ethernet network connection is used, it will be necessary to set the IP address and network parameters.
This operation must be carried out for each of the Previdia control panels and repeaters connected to the Ethernet
network via LAN cable.
To set the network parameters you must enter the programming phase of the control panel (
paragraph 2.2
)
and then tap on the appropriate icon inside the control panel configuration screen.
Get date and time
Ethernet
Time zone
Cloud failure delay
0060
(min)
Esc
Set
Access level:3
