14
Repeater based on TCP/IP
Fire detection and extinguishant system
Chapter 5
Repeater based on TCP/IP
If you intend to configure a Praesidia control-panel repeater on a TCP/IP network, it is necessary to have an FPMCPU
module.
After proper installation of the module, you must connect the Ethernet cable then proceed with the configuration
process, first via the repeater touch screen then, successively, via the Presidia-Config programming software.
Via the display
First of all you must assign an IP address to the repeater:
1.
Press the
Programming
button on the home page of the display and
enter an access code valid for level 3 (code “00004” at default)
2.
Access the
Network
section and assign a valid IP address (
[A]
,
192.168.1.121 at default).
3.
Press the
OK
button
[A]
to exit and save.
After doing so, it is necessary to check that the address of the repeater is “0”.
To do this it is necessary to access the
Programming
section, as indicated
above, then access the
Configuration
section.
The configuration process continues through the control pane programming software.
Via Praesidia-Config
To configure an IP repeater, it is necessary to start from a solution that already exists.
1.
Go up to the “System” section
[A]
and
click-on the
Add
button
[B]
.
2.
On the window that opens, double click-
on the repeater icon. The repeater will be
added at the side of the first cluster in the
top part of the section
[C]
.
The warning icons
[D]
inside clusters 1 and 2
indicate that it is necessary to perform a write
operation in order to communicate to each
component in the network the existence of
the other elements.
Therefore, you must select the type of
communication connection with the
repeater.
3.
Click-on the icon of the repeater
[C]
and
then on the Settings button
[E].
The
respective window will open.
1HWZRUN
,3
%DFNXSSDQHO
1HWPDVN
*DWHZD\
(VF
3RUW
2.
$FFHVV
OHYHO
B
A
35$(6,',$
6\VWHP
&OXVWHU
&OXVWHU
&OXVWHU
C
B
A
E
D
D
