InHand ER805 User Manual
18
7.2 Uplink Settings
On the
【
Internet
】
page, you can configure link detection and set parameters for the uplink interfaces.
Figure 7-2 Uplink settings
By default, link detection is enabled. In the private network environment, please manually configure the
address that can be detected or disable the link detection function to prevent the cellular interface from
working normally. When this function is disabled, the
Status
page does not display the transmission
latency, jitter, packet loss rate, or signal strength on each uplink interface.
If the link detection address is left empty, the system detects the primary dns server address obtained by
each interface. When the IP address of the link detection is filled in, all uplink use this address as the
detection address
When the router works in link backup mode, you can enable the items to be detected. The router then
monitors these items and triggers a link switch when any item exceeds the threshold. If no item is
enabled, link switch is only triggered based on priority and connectivity of the links.
When the router works in load balancing mode, all the links forward traffic on a per packet basis.
