Ingeteam Ingecon Sun 250 TL, Руководство по установке

Страница: 87 / 92

87
Ingeteam Energy, S.A.
AAV2000IKI01
Installation manual
Screen 5
Rpv Impedance of the entire PV array to ground.
Rpv+ Impedance of the positive pole of the PV array to ground.
Rpv- Impedance of the negative pole of the PV array to ground.
Screen 6
Alarms Status of inverter alarms.
0000H No alarms.
0001H Grid frequency out of range.
0002H Grid voltage out of range.
0004H PI current saturation.
0008H Unexpected reset.
0010H Continuous overload at output.
0020H Temperature alarm in the power electronics.
0040H Hardware fault. Synchronisation fault.
0080H Instantaneous overload at output.
0100H AC circuit protection.
0200H DC circuit protection.
0400H Insulation fault.
0800H Power electronics fault.
1000H Manual shutdown alarm.
2000H Configuration change alarm.
4000H Panel input overvoltage.
8000H Low voltage in the PV array.
Alarm hist. Alarms since the last connection. This value is reset each time the inverter is connected to the grid.
It has the same code as the "alarms" variable.
TempInt Inverter power electronics temperature.
TempCL: Inverter control electronics temperature.
Screen 7
Conn.N:
Number of grid connections made during all hours of operation.
ParConn.N Number of grid connections since counter was last reset.
ConnT: Number of hours the inverter has been connected to the grid.
Par.ConnT: Number of hours the inverter has been connected to the grid since the counter was
last reset.
Screen 8
System status This parameter can have three states:
Initial status In start-up status.
Operational Status
Error status
MPPT Power Power injected by the inverter configured as master.
Slave power Power injected by the inverter of the node being measured.
Total Power Power injected by all the inverters configured in this master-slave system.