2
The use of other than genuine Powerforce by Ingersoll--Rand replacement parts may result in safety hazards, decreased
tool performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by an authorized Powerforce Servicenter. Call toll free 1 (866) 207-6923.
WARNING SYMBOL IDENTIFICATION
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Read this manual before
operating tool.
WARNING
OPERATIONAL AND MAINTENANCE INSTRUCTIONS
•
90 psig maximum at tool inlet.
•
Lubrication -- Inject approximately 1.5 cc of
Powerforce No. 50 Oil into the air inlet before
starting the tool and after each two or three hours
of operation, unless the air line lubricator is used.
Lubricate with 1.5 cc of Powerforce No. 50 Oil
before storage.
•
Periodically, inject several drops of Powerforce No.
50 Oil into the Ratchet Head.
•
Forward/Reverse Operation -- Turn the
forward/reverse dial (14) counter clockwise to
tighten a nut. Turn the forward/reverse dial (14)
clockwise to loosen a nut. If the threads are
left--handed, reverse the procedure.
(Dwg. TPD905--2)
F
L
R
Main Line(s) Inner Ø
to be 3X Size of
Air Tool’s Inlet Ø
To Air
System
To Air
Tool
Lubricator
Emergency
Shut--Off
Valve
Regulator
Filter
Compressor
FRL
Drain Regularly
Branch Line(s) Inner Ø
to be 2X Size of
Air Tool’s Inlet Ø
TROUBLESHOOTING
Problem
Possible Cause
Action
Low speed or tool will not function
Lack of lubrication
Add 1.5 cc of Powerforce oil #50 to
the tool
Low speed or tool will not function
Low pressure
Ensure system regulators are set
properly to have 90 psi (6.2 bar/
620 kPa) at the tool inlet.
Low speed or tool will not function
Low pressure
Ensure proper hose size. Long
hose lengths may require a hose
with a 1/2” ID or larger
Low speed or tool will not function
System leakage
Ensure connections are tight and
hoses are not damaged
Low speed or tool will not function
Debris build up in tool
Flush tool with 1.5 cc of
Powerforce oil #50
Ratchet head will not loosen nut or
mechanism slips
Torque of nut exceeds ratchet
capabilities
Hand tool with long lever arm or an
impact wrench (PF800) might be
needed to loosen nut
Low speed or tool will not function
Worn mechanism
Replace ratchet head
(PF705--RHK1 or PF775--RHK1)
SPECIFICATIONS
Model
Free Speed
rpm
Drive
in
Recommended Torque
Range
H
Sound Level
dB (A)
z
Vibrations
Level
Model
rpm
in.
Ft--lb
Nm
Pressure
Power
m/s
2
PF705
260
3/8”
5 to 24
7 to 32
92 2
105 2
5 4
PF775
260
1/4”
5 to 24
7 to 32
92.2
105.2
5.4
H
Tested in accordance with PNEUROP PN8NTC1.2
z
Tested to ISO8662--7
