25
Danger
Please utilise extreme caution when performing work within the compressor. Wear
appropriate PPE
(Personal Protective Equipment)
, follow
lock out-tag out
procedures, and
ensure all safety procedures
.
Pressing and holding the button for 3 seconds will enter the configuration menu.
The following screens can be viewed and manipulated. Exiting the configuration menu
is accomplished by allowing the indicator to remain idle for approximately 30 seconds
or by pressing and holding the button for 3 seconds. The display will revert back
to the Power Up / default screen.
Configuration Menu
Time of Day - The hours digits will begin to flash and can be
changed by pressing the to adjust the hours indication to the
correct value. Press to store the new value. The minutes digits
will begin to flash and can be changed by following the same
sequence as above. Pressing will store the minutes value and
toggle down to the next screen.
Pressure Calibration - Pressure Transducer calibration is
accomplished by first making sure there is NO pressure on the
transducer, then pressing and holding the and the button
for approximately 5 seconds. The display will begin to flash 0 and the
new Zero calibration value will be stored. Press the button to
exit the configuration menu and toggle down to the next screen.
Maintenance Timer Reset - Both the Runtime and Annual
Maintenance timers are reset by pressing and holding both the
and the buttons for approximately 5 seconds. The timers will
reset to zero and the display will begin to flash. Press and hold the
button for approximately 5 seconds till the display blanks then the
reset will take effect. Press the button to toggle to the next
screen.
Appendix 7 cont.
Hour Meter Adjust - The hour meter can be adjusted to any desired
value. Each digit will begin to flash and can be changed by pressing
the to adjust the digit to the correct value. Press to store the
new value and move right to the next digit. Each digit can be
changed by following the above sequence. Once the right most digit
is stored the display will toggle back to the beginning of the
configuration menu.
