3) DRILL COTTER KEY CONNECTION HOLE.
DRILL 1/8" DIA. HOLE THRU ON VERTICAL ROD 7/16" FROM END OF ROD JUST CUT.
B) FOR RODS THAT ARE TOO SHORT, FOLLOW PROCEDURE BELOW.
1) ATTACH EXTENSION RODS TO THREADED SECTION OF TOP ROD.
TOP ROD
2) FOLLOW INSTRUCTIONS TO MARK, CUT & DRILL TOP ROD (SEE PART A, STEP 1 ABOVE).
EXTENSION ROD
PAGE 8
1/8” DIA. HOLE THRU
7/16”
HARDWARE INSTALLATION
4
LHR SHOWN
PANIC (NO TRIM) - #14x1" PPHSMS.
PANIC (WITH TRIM OR SEXBOLTS) - 1/4"-20x3/4" PPHMS.
FIRE (ALL APPLICATIONS) - 1/4"-20x3/4" PPHMS.
1) IF USING OUTSIDE TRIM OR SEXBOLTS, MOUNT TRIM PER DIRECTIONS IN TRIM BOX, OR INSTALL OUTSIDE SEX BOLTS.
2) MOUNT DEVICE - SURFACE APPLY OR THROUGHBOLT DEVICE TO TRIM OR SEXBOLTS.
3) LOCATE, MARK AND DRILL END CAP MOUNTING HOLE:
A) LEVEL DEVICE.
B) MARK CENTER OF 5/16" DIA. HOLE AT END OF CHANNEL.
C) DRILL 9/32" DIA. HOLE THRU DOOR.
D) DRILL 3/8" DIA. HOLE ON TRIM SIDE OF DOOR USING 9/32" HOLE AS GUIDE.
DEVICE SIDE: 9/32" DIA. HOLE
TRIM SIDE: 3/8" DIA. HOLE
TRIM/CYLINDER HOLE
MOUNTING HOLES (2 QTY)
PAGE 9
LHR SHOWN
5) INSTALL END CAP MOUNTING BRACKET USING SEXBOLT AND MOUNTING SCREW.
4) INSERT CHANNEL COVER.
