FLUSH DOOR
"A" = 2-1/8"
"B" = 2-5/8"
"C" = 2-3/16"
"C" = 1-11/16"
(NOTE: FOR FACTORY PREPARED DOORS, VERIFY LAYOUT.)
1) DOOR MUST BE FITTED AND HUNG PROPERLY BEFORE PROCEEDING.
2) MARK MOUNTING , VERTICAL , AND DEVICE REF. ON DOOR AND FRAME (SEE FIGURES & CHART BELOW).
(NOTE: MOUNTING C AND VERTICAL C DIFFER BY 1/4". ALL DIMENSIONS TAKEN AT MOUNTING C).
A) MOUNTING :
2
DOOR LAYOUT
PAGE 2
CL
INSTALLATION
PAIR: (F)17-V
(F)17-V x (F)17-M
WITH OPEN BACK
STRIKE
17-V x 17-R
WITH 571 STRIKE
17-V x 17-R
WITH 571A STRIKE
TWO VERTICAL ROD DEVICES
VERTICAL ROD x RIM DEVICE
(571 OR 571A REQUIRED FOR THIS APPLICATION)
VERTICAL ROD x MORTISE DEVICE
(OPEN BACK STRIKE REQUIRED FOR
MORTISE DEVICE IN THIS APPLICATION)
NOTE: 571 AND 571A ARE NOT APPROVED FOR FIRE
RATED APPLICATIONS
1-3/4" MIN STILE
BACKSET
"A" = 1-1/8"
-
-
-
L
L
L
CL
CL
CL
A
A
C
C
B
B
LHR SHOWN
15) CHECK FOR SMOOTH OPERATION AND SECURE LATCHBOLT ENGAGEMENT. ADJUST STRIKE IF REQUIRED.
PAGE 15
B) REMOVE DOGGING KEY; TOUCHBAR WILL REMAIN DEPRESSED.
C) REINSERT DOGGING KEY AND TURN IT IN OPPOSITE DIRECTION (COUNTER-CLOCKWISE).
PUSH ON TOUCHBAR AND IT WILL "POP OUT."
D) FOR CYLINDER DOGGING, REFER TO INSTALLATION INSTRUCTION D-4080.
14) CHECK DOGGING OPERATION: (PANIC APPLICATION ONLY)
A) DEPRESS TOUCHBAR, INSERT AND TURN DOGGING KEY CLOCKWISE TO DOG DEVICE.
