Ingersoll-Rand BXR-60, Инструкция по установке / эксплуатации / техническому обслуживанию / запасным частям

Страница: 12 / 67

SECTION 4 - OPERATING INSTRUCTIONS
4-2
INSPECTION PRIOR TO OPERATION
CHECK ENGINE OIL
Before checking or refilling engine oil, be sure the rammer is located on a stable level surface.
Do not thread the gauge into oil filler to check oil level. If the oil level is below the lower level line on the dipstick, refill with the
proper oil to the upper level (to the neck of oil filler). See section 9.
CHECK ENGINE FUEL
Do not refuel while smoking, near an open flame or other potential hazards.
CLEANING AIR CLEANER
Check Air Cleaner to be sure it is clean and not comtaminated. If it needs cleaning perform the follwing steps:
Remove the outer urethane foam and inner element. Wash the element in kerosene or diesel fuel. Saturate it in a mixture
of 3 parts kerosene or diesel fuel and 1 part engine oil. Shake off excessive oil and reinstall. Wash the air cleaner case
using kerosene. After cleaning it up, apply engine oil on the inner part of the case.
If the air cleaner element is seriously contaminated engine start up may fail or poor output and malfunction of the engine
may result.
CHECK EACH PART FOR LOSE OR BROKEN BOLTS AND NUTS
Tighten loose bolts and nuts, if any. Check each part for fuel or oil leak. Replace broken or damaged parts, if any, with
new ones.
OPERATION
STARTING
1. Turn the STOP SWITCH (1, Figure 4-1) clockwise to the position “I” (ON).
Figure 4-1
1