Ingersoll-Rand 7802S, Руководство по эксплуатации и обслуживанию

Страница: 2 / 15

2
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by the
hose.
WARNING
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
90 psig
(6.2bar/620 kPa)
PLACING TOOL IN SERVICE
LUBRICATION
Ingersoll–Rand No. 50 Ingersoll–Rand No. 28
Always use an air line lubricator with this tool.
We recommend the following Filter–Lubricator–Regulator
Unit:
For USA – No C28–04–FKG0–28
After each two hours of operation, unless an air–line
lubricator is used, inject 1/2 cc of Ingersoll–Rand No. 50
Oil into (2) before attaching the hose.
Periodically, inject several drops of Ingersoll–Rand
No. 10 Oil around the blade pivot point.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)
SPECIFICATIONS
Model Strokes per Minute Max. Material Thickness
7802S 4,200 20 Ga.