Ingersoll-Rand 2115P4Ti, Инструкция по эксплуатации

Страница: 34 / 36

Form P7748 Edition 1 34
TROUBLESHOOTING GUIDE
Trouble Probable Cause Solution
Low power
Dry Motor
Daily, inject 3 cc of Ingersoll-Rand No. 10 Oil into the inlet and run
the tool to lubricate the motor.
Inadequate air supply
Install proper air supply and connection. Refer to Dwg. TPD905-
2 and Dwg. TP2132 on page 4
Dirty Inlet bushing Screen
Using a clean, suitable, cleaning solution in a well ventilated area,
clean the Inlet Bushing Screen.
Worn or broken Vanes Replace a complete set of Vanes.
Worn or broken Cylinder and/
or scored End Plates
Examine Cylinder. Check outside and ends for wear or damage and
inside for scored or wavy bore.
Replace Cylinder if any of these conditions exist.
Replace End Plates if they are scored.
Dirty motor parts.
Disassemble the Tool and clean in a clean, suitable, cleaning
solution in a well ventilated area. Assemble the Tool and inject 3 cc
of the recommended oil into Inlet and run Tool to lubricate internal
parts.
Damaged Reverse Valve Replace Reverse Valve.
Motor will not run
Incorrect assembly of motor
Disassemble motor and replace worn or broken
parts and reassemble.
Insufficient lubricant in the
impact mechanism
Lubricate impact mechanism through Hammer Case Grease Fitting
using the recommended grease.
Tool will not impact Broken or worn impact
mechanism parts
Remove Hammer Case Assembly and examine impact mechanism
parts. Replace any worn or broken parts.
Impact Mechanism not
assembled correctly.
Reassemble Impact Mechanism.