5
R
e
v
is
ió
n
: 0
5
R
e
f.:
M
A
N
U
_
V
B
Z
1
6
/0
2
/2
0
1
7
Furthermore, the floor at the final location must be strong enough to support the total weight
of the cabinet plus the maximum product load. Also, it must be level and free of vibration. Reinforce the
floor if necessary.
These Infrico units are shipped from the factory on a wooden pallet and packaged in a wooden
container. The wooden is attached to the wooden base with the use of large staples. These should be
first removed to avoid scratching the unit when lifting off the crate.
All packaging materials used are environmentally friendly and may be recycled or reused.
Actively contribute to the protection of the environment by insisting on packaging recovery and removal
methods that are environmentally friendly.
NOTE: Infrico does not recommend laying the unit down on its front, side or back. However,
you must be certain to allow the unit to remain in an upright position afterwards for at least 24 hours
before plugging it in so that the compressor oil and refrigerant may settle.
To assure maximum operating efficiency, the equipment should be located where a continuous
air supply can circulate underneath and behind the cabinet.
Restricting the air supply will generate an excessive heat load on the condensing unit and
adversely affect its operating efficiency. Do not at any time obstruct the grill area in the front of the
cabinet in any way.
NOTE: Any restriction of the proper air flow, total or partial, will avoid the warranty on the
unit.
It is extremely important that the cabinet is perfectly level for proper operation so that the
drain pan will drain properly, the doors will line up with the frames and the unit will not be subject to
undue strain.
In VBZ, we install feet adjustable from factory. You can adjust these feet as you wish.
5.2
Uncrating
5.3
Ventilation
5.4
Leveling
