Chapter 5: System Maintenance
Figure 5-3: Removing the Controller Module
WARNING!
Unnecessary tampering with the controller module can cause severe and
permanent damage. Only move the controller module if it is absolutely
necessary.
When replacing a controller module from the subsystem, all anti-static
preventative techniques should be strictly adhered to.
5.2.3
Installing a Replacement Controller
To install a replacement controller:
Step 1.
Remove the failed controller from the subsystem
(see
Section 5.2.2
.) It is recommended to obtain a replacement
with pre-installed memory. If the DIMM module is
obtained otherwise, refer to
Section 5.3
for details on
handling controller and DIMM module.
S
t
NOTE:
Contact your vendor and provide information of your surviving controller.
You may access the “System Information” menu in the firmware
configuration utility for details.
Step 2.
Install the replacement controller.
Make sure the levers
at the back of the controller are at their lowest positions.
Align the controller module with the controller module
bay. Gently slide the controller module in. (See
Figure 5-
4
)
Replacing Controller Module Components
5-5
