EonStor F16F-R/S4031 Installation and Hardware Reference Manual
high or open
4
MOD_DEF(
2)
Module Definition 2: Data line for Serial ID
5
MOD_DEF(
1)
Module Definition 1: Clock line for Serial ID
6
MOD_DEF(
0)
Module Definition 0: Grounded within the
module
7
Rate Select
No connection required
8
LOS
Loss of signal indication; Logic 0 indicates
normal operation
9
V
EER
Receiver Ground (common with Transmitter
Ground)
10
V
EER
Receiver Ground (common with Transmitter
Ground)
11
V
EER
Receiver Ground (common with Transmitter
Ground)
12
RD- Receiver
Inverted
DATA out; AC coupled
13
RD+ Receiver
Non-inverted DATA out; AC coupled
14
V
EER
Receiver Ground (common with Transmitter
Ground)
15
V
CCR
Receiver Power Supply
16
V
CCT
Transmitter Power Supply
17
V
EET
Transmitter Ground (common with Receiver
Ground)
18
TD+
Transmitter Non-inverted DATA in; 100 ohm
termination between TD+ and TD-; AC coupled
thereafter
19
TD-
Transmitter Inverted DATA in; See TD+
20
V
EET
Transmitter Ground (common with Receiver
Ground)
Table C-1: 4G FC Port Pinout Definitions
C.2
COM1 Serial Port Cable
COM1 Cable:
This cable connects between COM1 serial port on the
controller module to the serial port of a management computer. The serial
port’s defaults and requirements are:
1.
Set at 38400 baud, 8 bit, 1 stop bit, and no parity.
2.
In most cases, connecting RD, TD, and SG is enough to establish
communications with a terminal.
PN: IFT-9270ASCab
C-2
COM1 Serial Port Cable
