35
6
Lift and grasp the pull tab and lift the module out (Figure 22).
Dispose of the lamp module in an environmentally proper
manner.
F
IGURE
22
Removing the lamp module
WARNING:
Do not drop the
lamp module or touch the glass
bulb! The glass may shatter and
cause injury.
7
Install the new lamp module, being sure to align the connec-
tors properly.
8
Push the module in until it is flush with the bottom case of the
projector.
9
Tighten the screws on the outside of the module.
10
Replace the lamp door by inserting the hooks on the lamp
door into the slots on the projector and pressing the lamp door
into place. If the lamp door does not fit properly or bulges out,
remove the door and re-seat the lamp module.
11
Plug in the power cord and press the Power button to turn the
projector back on.
12
To reset the lamp hour counter in the Status window, press
and hold the
volume -
button, then press the
menu
button
(while still holding down the
volume -
button) for 5 seconds.
Verify that the counter was reset by pressing the
menu
button
and viewing the counter in the Status window.
pull tab
Содержание LP340B
Страница 12: ...6 I n t r o d u c t i o n ...
Страница 38: ...32 U s i n g t h e P r o j e c t o r ...
