www.infocus.com
Basic
28
Startup/shutdown
• Use 100-240V AC as the power supply.
• Power button on the panel and the remote control can be used to switch between
power-on and standby states. The main power switch on the rear panel has options,
Press the “O” to power off the product; press the “I” end to power it on.
Auto standby
• In the Android main interface, whether there is signal input or not, the product will
not enter the standby mode.
• In the non-Android main interface, if there is no signal input within 15min, the
product will automatically enter the standby mode.
Save before shutdown
• Before shutdown, the product will save the picture and sound settings. Upon restart,
these settings will be used.
OPS On/Off
• If the product is installed with the OPS module and it is in
OPS signal source, the OPS module will start automatically.
If not, start it manually.
• Before turning off the product, first use the touch function or mouse to turn off the
OPS module from the Start menu. The Standby key on the panel or remote control
can be used to turn off the product only after the OPS module completely shuts
down. It is not allowed to press the Standby key or directly disconnect the power
supply without turning off the OPS module as it will damage the OPS module.
• When the OPS module enters the OFF state and no operation is performed on the
PC for a long period of time, this product will enter standby. To use the module, just
restart the product.
Sidebar Setting
Press the sidebar shortcut key arrow, or slide from the edge of the screen
inwards(when feature activated in main menu settings) to open the sidebar menu to
show system setting, signal source/menu setting, small tools, progress management,
switch to Android homepage, return and help.
Signal Source Switching
You can use the remote control or touch function to switch the source by the following
methods:
Method one:
1. Press the "Signal Source" key on the remote controller to call "Signal Source Menu
2. Press the cursor key on the remote control to select a signal source
3. Press the"OK" key, and then the product will switch to the input signal source that
you selected.
BASIC
Note
The OPS module
is optional.
