3. Enter code commands "66, SHOT" to set the current position as
the start point.
SHOT
6
6
4. The following overlay messages will be displayed, indicating the
start point has been defined, and the system is ready for setting
the other boundary.
SET AUTOPAN
To define the end point
1. Once the above messages are displayed, deflect the joystick to the
position to be set as the end point;
2. Enter code commands "66, SHOT" to set the current position as
the end point.
SHOT
6
6
3. Place the key switch at the OPERATE position.
OPERATE
PROGRAM
MENU
How to call the AUTOPAN
1. Place the key switch at the OPERATE position.
OPERATE
PROGRAM
MENU
2. Enter code commands "66, SHOT" to call the AUTOPAN.
SHOT
6
6
Below is the way to program the start/end point and call up autopan
under Up the Coax protocol:
To define the start point
1.
Use the joystick to move the camera to the position that is desired
as the start point;
2. Place the key switch at the PROGRAM position;
OPERATE
PROGRAM
MENU
3. Set the current position as the start point:
For example: enter code commands "66, SHOT" when use
V2015+V2414 (DATALINE convert to Up the Coax) +Up the
Coax dome.
6
6
SHOT
4. The following overlay messages will be displayed, indicating the
start point has been defined, and the system is ready for setting
the other boundary.
To define the end point
1.
Once the above messages are displayed, deflect the joystick to the
position to be set as the end point;
2.
Set the current position as the start point:
For example: enter code commands "67, SHOT" when use
V2015+V2414 (DATALINE convert to Up the Coax) +Up the
Coax dome
6
7
SHOT
3. Place the key switch at the OPERATE position.
OPERATE
PROGRAM
MENU
How to call the AUTOPAN
1.
Place the key switch at the OPERATE position.
OPERATE
PROGRAM
MENU
2.
Call up the AUTOPAN.
Enter code commands "64, SHOT" when DATALINE convert to
Up the Coax.
6
4
SHOT
6
