132
Infinity Chimp Series
Infinity Chimp Series
Once you chose the appropriate timing mode, you may either adjust the times by using the encoders or
by clicking on the encoder label for the appropriate attribute.
To remove individual timings you may ether press the [Off] Key and select one of the attribute groups
from the side menu or turn the encoder off the attribute you want to remove. Alternatively, you may click
on the encoder label and click on the appropriate
Clear
button on the bottom of the keypad dialog.
Fig. 104: Timing / Delay Keypad Dialog
Fanning Values (spreading values across different fixtures)
Fanning is a very useful function used to spread values across a range of fixtures.
Fanning of values may be applied to any fixture attribute, and to most effect attributes.
To activate fanning of attributes, press the
[Fan]
key on the consoles faceplate. The Encoder Labels will
add “Fan” to the encoder labels to indicate the fan functions status.
The fan function will remain active until you press the button again. However, if you keep holding the
[Fan]
button for a longer amount of time, the Fan-Function will only be turned on while you keep
pressing its button.
Bear in mind that the fixture selection order is important when fanning. For more information, please see
Fan any value using the Encoders:
Fanning using the Encoders for value entry will always use the current value that is output of a parameter
as base point. All values will be fanned relatively from that base point.
To fan an attribute in the programmer, or any of the effect parameters in the effect programmer:
●
Select fixtures 1 through 8 and set them to 50% intensity:
[1] [Thru] [8] [@] [50] [Enter]
:
●
Hit the
Intensity
attribute group from the Programmer Side Menu until the first encoder controls the
Dimmer attribute
●
Press the
[Fan]
key to toggle the fan function, or hold down the
[Fan]
Key and slowly turn the
Dimmer Encoder:
Fan Intensity Values using the Keypad.
