Drag and
Drop
Components
Figure 14
Place components in the design
PSoC
™
Creator gives each Component a default name and properties. Default values may or may not be
suitable for any given design. In subsequent steps, you modify the name and some of the properties
2.
Configure the LED pin
The output pin drives the LED. The LED on the PSoC
™
6 Wi-Fi-BT Pioneer Kit is active LOW; that is, the
logic HIGH pin-drive state turns OFF the LED, and the logic LOW pin-drive state turns it ON.
shows the configuration
Double-click the Component placed on the schematic to open the configuration dialog. Then, perform
the following steps:
a.
Change the name of the Component instance to Pin_GreenLED
b.
Deselect HW connection. The firmware will drive the pin
c.
Set the Drive Mode to Resistive Pull Up
Getting started with PSoC
™
6 MCU on PSoC
™
Creator
4 My first PSoC
™
6 MCU design using PSoC
™
Creator
Application Note
20
002-21774 Rev. *G
2022-07-21
