Figure 5
My first PSoC
™
6 MCU design
4.3
Part 1: Create a new project from scratch
This section takes you on a step-by-step guided tour of the design process. It starts with creating an empty
project and guides you through hardware and firmware design development stages.
Note:
These instructions assume that you are using PSoC
™
Creator 4.2. The overall development process is
the same for subsequent versions of PSoC
™
Creator; but the user interface may change over time.
Launch PSoC
™
Creator and get started.
1.
Ensure that PSoC
™
Creator can find the PDL
This should be set correctly automatically during installation, but nothing works if this isn’t set up right.
Refer to
for help with this step.
a.
Choose Tools > Options
b.
On the Project Management panel, check the path in the PDL v3 (PSoC
™
6 Devices) location
field
c.
Ensure that it is correct. If it is not, click the Browse button and locate the installed directory of
the PDL. The default location is
C:\Program Files (x86)\Cypress\PDL\3.0.1
Getting started with PSoC
™
6 MCU on PSoC
™
Creator
4 My first PSoC
™
6 MCU design using PSoC
™
Creator
Application Note
14
002-21774 Rev. *G
2022-07-21
