User Guide
54 of 56
002-32436 Rev. *B
<2021-06>
CY8CKIT-041S-
MAX PSoC™ 4100S Max pioneer kit guide
Hardware
−
Operate the actuator towards the center. Operating one side only may result in actuator damage or
incomplete mating.
−
Do not pull or pick at the actuator. Doing so may damage it. (Do not carry out any operation other than
the actuator rotation operation described above)
−
This connector utilizes bottom contacts. Insert the FFC with the exposed conductors face down.
−
Insert the FFC straight into the connector while at a 10° angle to the board surface (see illustration
below). Make sure that it has been fully inserted.
−
Do not insert the FFC diagonally. If the FFC is inserted in skewed orientation as illustrated above, the FFC
may get caught by the terminals resulting in terminal deformation.
−
After FFC insertion, lock the actuator.
4.
What third-party IDEs does this kit support?
−
Multiple third-party IDEs are supported; IAR and µVision are some examples. For more details on all
supported devices and procedures to export to these IDEs, see ModusToolbox
™
User Guide (Help -->
ModusToolbox
™
General Documentation --> ModusToolbox
™
User Guide [Section - 7. Exporting to IDEs]).
