43
Terminal block (detail)
PWR IN
9V-30V
WARNING:
Only
one of the following power input ports is permitted to be
connected at a given time: 12V Charger Port, IS Power Port, or 9–30
VDC Terminal Block.
To complete the fixed DC power connections, count the terminal-block
ports from left to right. Locate the fifth and sixth ports on the terminal
block. The following apply.
x
Port 5 is labeled "GND" and is used to connect the ground line.
x
Port 6 is labeled "PWR IN 9V-30V" and is used to connect the
compatible fixed DC power line that supplies an input voltage range
of 9–30 VDC with a maximum current of 5A.
x
Use these mechanical and electrical wiring specifications.
Mechanical:
o
Solid Wire: 18-12 AWG
o
Stranded Wire: 18-12 AWG
o
Torque: 4.0 lb in (0.45 N m)
Electrical: Shield wiring, or conduit, at the source
8
Connect optional Ethernet cable
If an Ethernet connection is to be used, connect the cable to its port.
9
Secure the cable and power line
Use the guides to secure the already connected Ethernet cable and
power line.
Lift any guide by its tab. Place the cable or power line in the guide's
groove. Lower and secure the tab to the guide base.
10
Close case lid and secure to case base
Ensure all wires and cables are secure, and are contained inside the case
and away from the unit's closure surfaces. This will support the integrity of
the items and full closure of the unit. If the strain relief on the Ethernet
cable resists full closure of the unit, a 90° adapter or short adapter cable
may be used. Close the case lid from left to right.
Using a T25 torx screwdriver, reinstall the four screws that secure the
case lid to the case base. Tighten them to a torque value of 1.69 N m
(240 oz in).
Figure 4.3 Installation for RGX that
includes
an external power source, Ethernet, or both
Operation Precheck
Power on the unit: On the case lid, press the power button for approximately 5 seconds until the power-
button light turns on.
Document Number: 0000037533
DO NOT CHANGE WITHOUT THE FOLLOWING AGENCY APPROVALS(S):N/A
Modified: 2018-05-25 13:18:14 EDT
State:In Work
INDUSTRIAL SCIENTIFIC CORPORATION
Title: PRODUCT MANUAL RGX GATEWAY-EN-1
Eng:
Drawing No: 17158071-1
Drawn By: Gaygan, Nancy
Created: 2018-05-16 10:24:51 EDT
Rev: 1
Printed By: Kuzmich, Bob
Int: 1.5
Date:May 29, 2018
