24
─
Check the unit's charging-status indicator light.
x
The green light will first
blink
on and off to indicate a
precharging state.
x
The green light will stay on, but stop blinking to indicate
charging is in progress.
x
The light will turn
off
to indicate the battery is fully
charged.
When the battery is fully
charged, unplug the power
cord from the outlet.
Disconnect the cable from the
port: turn its swivel cover
counterclockwise
(approximately 45°).
Cap the charging power
supply port: turn its swivel
cover clockwise
(approximately 45°) until it
clicks closed or a full-stop
connection feedback is felt.
Note:
always cap a port when
it is not in use.
Figure 3.2 Charge the unit
Power On and Shutdown
Locate the power button on the case lid.
Power on
Press the power button for approximately 5 seconds until the power-button light turns on.
x
If the unit is fully operational, the power-button light will be solid (not blinking) green.
x
For information about other light patterns and colors, see
Table 3.6 Power-button light
indicators.
Shutdown
Press the power button for approximately 7 seconds.
x
When the power-button light starts to blink, release the button.
x
To indicate unit shutdown is in progress, the light will blink red and green.
x
To indicate the unit is fully shutdown, the light will turn off.
Configuration
RGX configuration requires the use of one or two "apps", the RGX Configuration Interface (Interface) and
iNet software. Generally, as outlined below, the Interface is used to configure the RGX-to-iNet
communication settings; iNet software is used for all other RGX settings (see below). After initial
configuration, use each app as needed to edit the settings it supports.
Document Number: 0000037533
DO NOT CHANGE WITHOUT THE FOLLOWING AGENCY APPROVALS(S):N/A
Modified: 2018-05-25 13:18:14 EDT
State:In Work
INDUSTRIAL SCIENTIFIC CORPORATION
Title: PRODUCT MANUAL RGX GATEWAY-EN-1
Eng:
Drawing No: 17158071-1
Drawn By: Gaygan, Nancy
Created: 2018-05-16 10:24:51 EDT
Rev: 1
Printed By: Kuzmich, Bob
Int: 1.5
Date:May 29, 2018
