INDRA 190105A101, Руководство по установке

Страница: 12 / 50

12
Procedure
Existing cables MUST be inspected for damage and ensure they are suitably rated for
the Pioneer.
Choosing a location
• Select an installation location that ensures future servicing of the Pioneer,
where the back plate can be mounted flush to the wall and screws can be used
to permanently secure the charger in position.
• Make sure that all ventilation channels on the Pioneer are
free from obstruction and that the install location will not allow any
flammable material to come within 100 mm of the charger.
• The socket/ cable holster of the charger must be installed between
0.75-1.20m above ground level at the location of installation.
Mounting the station
Take out the mounting bracket. Using a spirit
level, position the top of the bracket horizontally.
Then, using the bracket as a guide, mark out the
four holes for drilling and/or screwing.
Ensure there is an Earth Connection to the Pioneer.
NOTE: ANY DAMAGED OR UNSUITABLE CABLES MUST BE REPLACED
Inspect the Pioneer to ensure the charger has not been damaged in transit,
not compromised and is safe to connect.
Isolate all electrical circuits and ensure they cannot be reconnected whilst
installation or servicing work is being completed. Use a proving device
where necessary.