Indian Motorcycle Indian Challenger 2020, Руководство пользователя

Страница: 131 / 178

NOTE
Adjust headlight aim when there is a change in load (rider, cargo,
accessories, etc.) or after suspension adjustment.
On LOW beam, the top of the horizontal cut-off of the light beam
q
should be 4 in. (10 cm) lower than the center of the headlight bulb
and centered straight ahead at 32 ft. 10 in. (10 m).
1. Verify that tire pressure is at specification.
2. Verify that rear suspension ride height (preload) is at
specification.
3. Position the motorcycle on a level surface with the headlight 32
ft. 10 in. (10 m) from a wall.
4. With the operator and passenger (if applicable) on board,
bring the motorcycle to the fully upright position.
5. Start the engine and switch the headlight to low beam. Observe
the headlight aim on the wall.
6. Make any necessary adjustments to headlight aim.
HHEEAADDLLIIGGHHTT AAIIM M AADDJJUUSSTTM MEENNTT
The headlamp adjustment screws
q
are located inside the
headlamp housing.
129
MAINTENANCE