Big Buck Hunter™
Page 10
Version 01/05
© Copyright 2004-2005 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved.
DRILL HOLE
7/32" (3 PLACES)
DRILL HOLE 1-1/2
GUN CABLE MOUNTING PLATE
HOLE PATTERN
Gun Installation
1. Insert the gun into the newly mounted holster.
The attached gun cable should be hanging freely,
with no loops or kinks.
2. Determine the best location for the gun cable
mounting bracket. Players should be able to
move the gun freely. Use the dimensions
indicated on the cabinet diagrams for
approximate placement. Be sure that once
installed, the wires from the gun cable assembly
will reach the power supply and PCB inside the
cabinet.
3. Position and attach the Gun Cable Mounting
Template to the cabinet. Be sure that the location
you have selected is free from bracing or wiring
inside the cabinet.
4. Carefully drill and deburr the 1 ½” center hole,
and the three .20 mounting holes.
5. Thread the cable connector and grounding wire
through the center hole.
6. Mount the Gun Cable Mounting Plate using the
supplied carriage bolts, flat washers and locking
nuts. Make sure the bolts are seated firmly.
Attach the grounding wire to any one of the
carriage bolts before installing the washer and
locking nut.
7. Once the Gun Cable Mounting Plate is mounted
securely, Make sure the gun can move freely in
all directions.
8. Inside the cabinet, connect the Cable Connector
to the supplied Connecting Harness. The
Connecting Harness then connects to GUN 1
connector on the main PCB. See the Wiring
section of this manual for more details.
W
IRING AND
H
ARDWARE
A
SSEMBLY
REMEMBER! DO NOT WORK WITH ANY PART OF
THIS SYSTEM PLUGGED IN (Lights, Monitor, or
Power Supply).
NOTE:
All switch wires used in this game need to be wired to
the normally open connection on the switches. Each
switch requires a ground wire on the common
connector and the appropriate control or switch wire on
the other normally open connector of the switch.
Control Panel Assembly
Wire the controls using the JAMMA Harness
Connection table. Connect the gun using the supplied
connecting harness cable into GUN 1 on the main
PCB.
Printed Circuit Board (PCB)
BIG BUCK HUNTER uses a hard drive to store its
game data. Make sure you mount your PCB in such a
way as to allow easy connections to the hard drive
cables. Refer to the next section for suggested
mounting positions.