inada Flex 3s HCP-S373A, Руководство по эксплуатации

Страница: 24 / 32

23
TROUBLESHOOTING
If there is still a problem after trying the solutions given in this troubleshooting guide, stop using the chair
immediately to prevent accident or injury, and unplug the power plug from the wall outlet. Contact your
local Inada distributor (see back page) for assistance.
Problem Cause & Solution
The right and left rollers are
out of alignment.
The rollers are designed with an
alternating tapping mechanism,
so in the stopped position they are
sometimes out of line.
This is part of the design and is not
a malfunction.
T
his is par
t of the design and is not a
malfunc
tion.
The rollers moved up to the
top and then stopped.
The auto timer will cause the rollers to move up to the top of the
chair when the massage time is fi nished, so as not to interfere
with your movements when getting out of the chair.
The rollers stop during the
massage.
Sometimes when there is too much pressure to the rollers, they
can stop moving temporarily. Slightly lift your body or lightly
raise the reclining seat back. (Be especially careful when a
person who weighs 100 kg (220 lb) or more uses this chair.)
The button of the remote
control and the session
button fl ash.
Set the main POWER switch located at the front right of the
chair to OFF, and then back ON after about 5 seconds.
If ther
e is still a pr
oblem af
ter the check, st
op using
the pr
oduc
t immedia
tely
.
The automatic shiatsu
point locator function is
not working properly.
(The height of the rollers does not match
the shoulders.)
Sit further back in the chair so that your head rests fi rmly on the
headrest. You can adjust the shoulder position with the ROLLER
buttons immediately after the shiatsu points are located.
Remote control buttons
do not seem to be
operating normally.
Or the power does not
turn on.
Check for the following:
① Is the power cord fully plugged into the wall outlet?
② Is the power switch located on the right side of the chair set to ON?
③ Are you pressing two buttons at the same time?
The power cord or plug is
abnormally hot.
Stop using immediately.
1.5 cm
(0.6 inch)
1.5 cm
(0.6 inch)
For details, contact your local Inada distributor.
[T
ROUBLESHOO
TING]
Anyone other than an authorized serviceperson must not repair or disassemble.