8
[BEFORE USE]
How to Remove and Install the Armrests
If the clearance of the transportation passageway is less than 87 cm (34 inch), removing the armrests is
recommended before transporting the chair.
Minimum product width when armrests installed: Approx. 83 cm (32 inch)
Minimum product width when armrests removed: Approx. 61 cm (24 inch)
For safety, before removing or installing the armrests, turn off the main power and disconnect the power cord
connector from the power connector on the chair.
* For installation, perform the procedure in reverse.
Read the installation precautions carefully.
①
Open the zipper on the armrest.
②
Remove the air hose and harness.
Caution
Correct: Connector tab on the front
Incorrect: Connector tab on the rear
Air Hose
Harness
Air Hose
●
To prevent
disconnection, be sure
to check the connection
after connecting by
gently pulling on the
connector.
●
If the connector is not
connected properly,
an error is generated.
After connecting, be
sure to turn on the main
POWER switch to check
for errors.
●
Installation precautions
Insert the power cord into the power connector, turn on the
main power and use the reclining button on the operating
mechanism to raise the chair to its fully upright position.
Then, pull the leather by hand to straighten out the wrinkles,
and close the zipper.
*For details on turning on the main power, see page 10.
●
Installation precautions
Содержание Flex 3s HCP-S373A
Страница 31: ......