Cheetah Python Cameras User Manual | CoaXPress (CXP) Interface
August 27, 2019
Page
27
of
86
Rev 1.0
Camera Startup
During camera power-up or receipt of a ‘DeviceReset’ command, the camera performs the
following steps:
1.
Boot loader checks program flash memory for a valid firmware image and loads it
into the field-programmable gate array (FPGA).
2.
The camera reads the “Boot From” register from the parameter Flash and loads a
workspace from one of the configuration spaces as determined by the User Set
Default Selector. The configuration spaces are: Factory Space, User Space #1, and
User Space #2.
3.
The camera completes startup and accepts user commands.
GenApi Camera Configuration
The following XML parameter nodes provide parameter names, descriptions, interface
type, range of control values, and the access mode for the parameter (RW: Read/Write, RO:
Read Only, WO: Write Only).
In the following tables, parameter names underlined in
red bold italic
letters indicate that
you must turn image acquisition
off
in order to change the parameters. You cannot change
these parameters if image acquisition is
on
. After making changes, you can turn the camera
image acquisition back
on
.
