29
Advanced Features
The PowerSync 16-80 includes an auto-sync triggering function. This synchronizes your
remote flashes with a camera’s shutter release using only
three transceiver units, meaning
you can trigger both your camera and flash wirelessly using three transceivers.
To set up your devices for the auto-sync triggering mode, please use the following
instructions:
1. Turn on the transmitting (in-hand) transceiver and set it to Transmitter (Tx) or Transmitter/
Receiver (Tx/Rx) mode using the M button and select a channel and group.
2. With the device turned off, connect the second (on-camera) transceiver device to the
camera using the camera dedicated shutter release cable into the shutter release [
]
port. Install and secure the device to your camera’s hot shoe.
3. Turn the on-camera transceiver on and set it to Transmitter/Receiver (Tx/Rx) mode using
the M button. Match the unit’s channel and group to that of the transmitting (in-hand)
transceiver.
4. With the third (on-flash) transceiver off, connect and secure it to the remote flash (See
Page 14 for mounting to flash instructions). Once this is completed, turn it on.
5. Set the (third) on-flash transceiver to Receiver (Rx) mode using the M button. Set it to
one channel above that of the first two units. For example, if the in-hand and on-camera
Auto-Sync Triggering for Cameras and Flashes