10
Mode Selection
Transmitter (Tx:)
Transmitter mode sets the transceiver to only send out signals to other devices.
No incoming signals will affect the device while this mode is initiated.
Receiver (Rx):
Receiver mode sets the transceiver to only accept incoming signals from
transmitting devices. This mode does not allow the device to send out signals.
Transmitter/Receiver (Tx/Rx):
Transmitter/Receiver mode allows the transceiver to both send and receive
signals to or from other devices simultaneously.
To change the mode on your PowerSync 16-80, press and hold the M button until
the current mode begins to blink on the LCD screen. Press the M button again
until your desired mode is displayed on the LCD screen.
NOTE: Using Tx/Rx mode increases the chance of signal interruptions between
communicating devices in the presence of many PowerSync 16-80 units. For the
most reliable signal transmission or reception, use either Tx or Rx mode when
possible.
