1
6
9
5
7
8
2
3
2
4
4
Page 1
ASSEMBLY
(1)
Insert the search coil cable through the hole at
the back of the lower shaft.
(2)
Insert the washers on the lower shaft yoke.
(3)
Insert the lower shaft yoke between search coil
mount tabs.
(4)
Attach the search coil to the lower shaft using
the lever and winged nut without over-tightening.
(5)
Fully insert the middle shaft into the lower shaft
and push it until it contacts the stopper. Then,
secure with the lever latch. If the lower shaft is not
inserted fully, the connector at the end of the cable
will not come out from the top of the shaft in the
next step.
(6)
Join the two connectors of the system box cable
and coil cable paying attention to the pins, then
tighten. The system box cable is a retractable spiral
and you can pull it in case you cannot join the two
connectors easily.
(7)
Join the middle and the upper shafts. Pull the
excess cable out of the hole and push the lever
latch on the upper shaft to secure. To adjust the
shaft length, loosen the lever latch on the middle
shaft, adjust the length to your height and press
the latch to secure.
(8)
To adjust the armrest, loosen the bolts. Slide the
armrest up and down to adjust it to your arm and
secure by tightening the bolts.
(9)
Adjust the armrest strap to your comfort.