Immergas 3.029660, Инструкция и предупреждение, Страница: 12 / 36

12
L
A
P
H
45°
2
INS
TALLER
US
ER
MAINTEN
AN
CE TECHNI
CI
AN
1.4 MAIN DIMENSIONS.
1.5 SPECIFICATIONS ON WATER QUALITY.
The supply water of the SOLARSMART solar collector with in-
corporated accumulator tank must permanently comply with the
limits indicated in the following table:
PARAMETER MEASURING UNIT REFERENCE VALUE
pH - 6,0 - 9,5
Chloride mg/l < 2500
Residual
disinfectant
mg/l < 0,2
Iron μg/l < 400
Sulphate mg/l < 500
Conductibility μS/cm at 20°C < 2500
For any parameters not listed in the table, the limits imposed for
water intended for human consumption are applicable, as laid
down by Directive 98/83/EC and subsequent amendments, and
as transposed by the respective decrees of each EU Member State,
including the outermost regions (ORs) and overseas countries
and territories (OCTs). For non-EU countries, the limits set by
the local regulations shall be applicable.
The collector cannot be used with sea water, swimming-pool water,
or any other fluids differing from water. The use of water that fails
to comply with the provisions in this paragraph will invalidate
the product warranty. The electrical resistors (antifreeze and in-
tegration) can be used with chlorine levels up to twice the limit
imposed by Directive 98/38/EC and subsequent amendments.
1.6 HARDNESS
It is recommended to use water with a hardness of between 10° F
and 30° F. In the case of water with a greater hardness than 30° F
it is recommended to carry out a softening treatment, otherwise
the SOLARSMART solar collector and its components, such as
the by-pass valve, safety and non-return valve, electric resistors,
etc., may be subject to limestone deposits and as a result, any
damage to the collector caused by the malfunctioning of the
aforementioned components (valves and resistors) will not be
covered by the warranty.
Damage to the valves and resistors as a result of the hardness of
the water, should this exceed the recommended limits, will not
be covered by the warranty.
If the water has a hardness of over 30°F and is not softened, there
could be a drop in the final yield and it will be necessary to carry
out periodic maintenance operations on the valves and resistors,
with an appropriate frequency depending on the hardness level
in order to guarantee correct operation over time.
MODEL
BIANCO LUNARE
SOLARSMART 110
3.029661
SOLARSMART 150
3.029663
SOLARSMART 220
3.029665
SOLARSMART 260
3.029667
MODEL
ROSSO COPPO
SOLARSMART 110-R
3.029660
SOLARSMART 150-R
3.029662
SOLARSMART 220-R
3.029664
SOLARSMART 260-R
3.029666
External dimensions
(L x P x H)
2.136 x 711 x 217mm 2.136 x 906 x 217mm 2.136 x 1.296 x 217mm 2.136 x 1.491 x 217mm
Inclination height 45°(h) 620mm 760mm 1035mm 1170mm