62
o
Ethernet 2:
preferably use Ethernet 2 to connect to the server. If the server is not
in the same subnet as Ethernet 2, and no default gateway is set for Ethernet 2, this
setting will be ignored.
Primary App:
Enter the application name in the primary server, as discussed above.
Consult your CDN or server documentation to find out what should be entered in this
field.
Primary Server URL:
This informational field is automatically updated as you
configure the RTMP parameters. It displays the full RTMP URL for the primary server.
Primary Stream:
Enter the stream name for the primary server. Consult your server
documentation or CDN to find out what should be entered here. Some servers allow
arbitrary stream names, while others use this field for authentication and thus require
specific names.
Backup Server:
If you have a backup RTMP server, configure it here; otherwise, this
field can be left empty. The encoder will only attempt to contact the backup RTMP
server if it cannot establish a connection with the primary server.
Backup Network Interface:
Select the network interface to be used when contacting the
backup server. The meaning of the choices is the same as the
Primary Network
Interface
described above.
Backup App:
Enter the application name in the backup server. If this field is left blank,
the value entered for
Primary App
is used.
Backup Server URL:
This informational field is automatically updated as you configure
the RTMP parameters. It displays the full RTMP URL for the backup server.
Backup Stream:
Enter the stream name for the backup server. If this field is left blank,
the value entered for
Primary Stream
is used.
Redundancy Switch Time (sec):
This field is only displayed if a
Backup Server
is
specified (i.e., it will not be present if
Backup Server
is left blank). It sets the timeout
for encoder to switch servers after the RTMP connection is established, if the server stops
accepting data (i.e., when the
IP Output Rate
goes to zero).
Port Selection:
If your RTMP server is using the default TCP ports for the protocol
variant, select
Use Default
. If your server is using a non-standard port, select
Specific
Port
. When
Specific Port
is selected, an additional field is displayed:
Port:
This field is only displayed if
Port Selection
is set to
Specific Port
. Configure a
non-standard TCP port here.
Authentication:
Some RTMP servers require username/password authentication for
access. If your server does not require authentication, select
No
, otherwise select
Yes
. If
you select
Yes
, additional fields are presented:
Содержание ITV-IP360c
Страница 25: ...25 Statistics Panel Configuration Panel Reflected in the front Status LED...
Страница 89: ...89...
