IMKO SONO-DIS, Руководство пользователя

Страница: 49 / 60

49
3 How to use the SONO-DIS kit
3.1 Measurements directly in the sand and gravel pile
For measurements in sand and gravel pile, make sure that the probe rods are inserted in the material down to the
gray probe bottom, so that the rods are in any case fully covered by the material.
To obtain a representative moisture value of the material, select the operating mode "Average Value" and take
measurements at different locations.
NOTE:
After rain, the material is usually more wet in surface areas compared to the core volume. Of course this is vice
versa after periods of drought. Then, the material dried up on the surface, but contains more water in the core
volume. Therefore it is recommended to measure at different locations of the pile