800-WMAGNET
10 of 21
SAFETY HOOK LATCH
Always use a safety hook latch onto the
crane hook to hold the magnets.
STAY CLEAR OF THE LOAD
Guide the load by pushing or pulling the
edges of the load.
Stay clear of the load at all times.
PLATE LIFTING
Position the magnet so that it is
centered on the plate. Never lift any
plate less than 1/4” (6mm) thick.
(See Important Facts 2 & 4).
BAR LIFTING
When the load width is greater than the
magnet diameter, position the magnet
length so the entire lifting surface of the
magnet is in contact with the load.
When the load width is narrower than
the magnet’s diameter, position the
magnet so that it is centered on the
width of the load.
Never lift loads with any dimension greater than:
CER05: 5 feet (1.5 meters)
CER07: 6 feet (1.8 meters)
CER09: 8 feet (2.4 meters)
CER12: 10 feet (3.1 meters)
CER16: 12 feet (3.7 meters)
CER20: 15 feet (4.6 meters)
RECOMMENDED LIFTING PROCEDURES
