IMG STAGE LINE BEAM-20LED, Инструкция по эксплуатации

Страница: 11 / 28

9
Control Modes
There are 4 modes: • Stand-alone (built-in programs)
• Sound-controlled
• Master/Slave
• DMX512 (12 Channels ADVANCED or 9 channel BASIC)
One BEAM-20LED ( Built-in Programs )
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (
IMG Stage Line TAR-1004SAVE / TAR-603SAVE
).
3. When the
BEAM-20LED
is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 15 for more information about the built-in programs.
One BEAM-20LED (Sound-control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (IMG Stage Line TAR-1004SAVE / TAR-603SAVE ).
3. When the
BEAM-20LED
is not connected by a DMX-cable, it functions as a stand-alone device. Turn on
the music. If the device is set to sound-control, then the BEAM-20LED will react to the beat of the music.
Please see page 15 for more information about the sound-control options .
Multiple BEAM-20LED s ( Master/Slave control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (IMG Stage Line TAR-1004SAVE / TAR-603SAVE ).
3. Use a 3-p XLR cable to connect the
BEAM-20LED
.
The pins:
1. Earth
2. Signal -
3. Signal +
4. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can
use the same functions on the master device as described on page 15 (Built-in Programs, or Music
control). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
Multiple BEAM-20LED s ( Master/Slave control)
Fig. 3