IMET Spa BS 300 PLUS SH, Инструкция по эксплуатации

Страница: 27 / 53

INSTRUCTIONS FOR USE
BS300 Plus SH ED.2010 rev.00 27/53

Please remember to abide by the current Law Norms concerning the draining of:
- materials used by the machine (for example hydraulic circuit oil, reduction gear oil, oil for installations of
lubrication and so on);
- scrap materials or materials not usable anymore (for example ferrous and not ferrous chips, tools like
blades and so on);
- substances used for cleaning and maintenance;
- materials used in some instances of the machine life (for example when packing, shipping and so on).
-21 - DEFECTS IDENTIFICATION
The solution of most inconvenients that could happen during the working can be found by consulting this
paragraph.
The first part concerns the machine working and includes a list of the possible defects with respective
controls that must be made; the second part concerns the inconvenients that can be found by checking the
blade and / or the cut pieces.
If your problem is not included in the forseen ones or you need the presence of qualified technicians, please
get in touch with the manufacturer or the reseller by keeping in evidence this instruction book .
12.1 - DEFECTS CAUSED BY THE MACHINE
Inconvenients Check
A* The band electric motor does not work 3-4-5-9
B* The hydraulic circuit motor does not work 1-2-3-4-5-9-17
C* The electronical/electric panel does not light on 6-7-8-9
D* No enough pressure in the hydraulic circuit 10-11-12-13
E* The pump of the hydraulic unit is noisy 14-15-16-17
F* The coolant is not sufficient 18-19-20-21
G* The workpiece moves or deformes 22-23-24
H* The cycle don’t start
23
LIST OF THE PARTS THAT MUST BE CONTROLLED
1 = Plug is right inserted in the socket
2 = Main switch
3 = The motor is burnt or demaged
4 = Electric supply is not right
5 = Transmission blocked between blade and blade arbor
6 = Fuses on the primary of the transformer
7 = Fuses on the secondary of the transformer
8 = Transformer demaged or burnt
9 = Connection of the supply cables
10 = Oil level in the tank of the hydraulic unit
11 = Loss from pipes and/or connections
12 = The adjustments screw of the maximum pressure valveis loosened
13 = the maximum pressure valveis broken
14 = Quality of the hydraulic oil (consumed, too much liquid)
15 = There is some water in the oil and / or there is some condensate in the tank
16 = Too high circuit pressure (over 20 BAR)
17 = The hydraulic pump locked (seizure, expansion, oxidation)
18 = The circuit taps are closed
19 = The cooling filters are obstructed or must be cleaned
20 = The electropump does not work (see 3-4-5-9-24)
21 = The tank is empty or dirty
22 = Excesive cutting feed
23 = The vice is not closed enough (or is too closed), the piece is not rightly clamped