Imax B6 LiPro, Инструкция по эксплуатации

Страница: 16 / 32

WARNING AND SAFETY NOTES
There is a 3-pin port on the left of the charger used as USB interface or temperature sensor port.
If the screen displays temperature, you can use the optional temperature probe to connect to the
surface of the battery. If it is set as the USB port, you can connect the charger to your PC through
the optional USB cable to monitor the charging process through optional software.
The maximum temperature of the battery can be set during the charge process. The process will
be terminated automatically to protect battery once the temperature of battery reaches this
value. This feature is accomplished through temperature probe (optional).
INC
INC
INC
INC
INC
INC
INC
INC
INC
INC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
-
-
-
-
-
-
+
+
+
+
+
+
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
W a s t e t i m e
C H G / D C H G 5 m i n
C a p a c i t y C u t - O f f
O N 5 0 0 0 m A h
S a f e t y t i m e r
O N 1 2 0 m i n
INC
INC
DEC
DEC
- +
LiFe
V.Type 3.3V
K e y B e e p O N
B u z z e r O N
LiFe
V.Type 3.3V
I n p u t p o w e r l o w
C u t - O f f 1 0 . 0 V
- +
INC
DEC
The battery becomes warm after cycles of charge/discharge process. The
program will insert a time delay after each charge/discharge process to
allow the battery enough time to cool down before beginning next cycle of
charge/discharge process. The valid value ranges from 1 to 60 minutes.
When the charge process starts, the integrated safety timer starts to run
simultaneously. If error detected or the termination circuit can not detect
whether the battery is fully charged or not, this unit is programmed to prevent
overcharging. Please refer to the below statement to calculate the timer you
set.
The program provides maximum capacity protection function. If the Delta-
peak voltage can not be detected or the safety timer times out, the charge
process will stop automatically, when the battery reaches the user-set
maximum charge capacity,
The beep to confirm users' operation sounds every time a button is pressed.
The beep or melody sounds at various times during operation to confirm
different mode change. These functions can be switched on or off.
This function monitors the voltage of the input battery used to power this
charger. If the voltage is lower than user-set value, the program will end
forcibly to protect the input battery.
15