Imax B6 LiPro, Инструкция по эксплуатации

Страница: 15 / 32

LiFe
V.Type 3.3V LiFe
V.Type 3.3V
LiPo/LiIo/LiFe
CHK Time 10 min
NiCd Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
L i F e
V . T y p e 3 . 3 V
L i P o / L i I o / L i F e
C H K T i m e 1 0 m i n
N i M H S e n s i t i v i t y
D . P e a k D e f a u l t
N i C d S e n s i t i v i t y
D . P e a k D e f a u l t
U S B / T e m p S e l e c t
T e m p C u t - O f f 8 0 C
INC
INC
INC
INC
INC
INC
INC
INC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
-
-
-
-
+
+
+
+
To avoid from erroneous setting by users,B6 detects the cell count of
Lithium battery automatically at the beginning of charge or discharge
process. But battery that is deep-discharged can't be detected correctly.
To avoid this error, the time term can be set to verify the cell count by the
processor. Normally, 15 seconds are enough to detect the cell count
correctly. You need to extend the time term limit for the battery of large
capacity. But the charge or discharge process may come to an end
within the time term because of the time limit decided by the wrong count
if you set too long time limit for the battery of small capacity. This may
cause fatal error. You have to extend the time term if the processor
detect the cell count incorrectly at the beginning of charge or discharge
process. Otherwise, default value is recommended to use.
This shows the trigger voltage for automatical charge termination of
NiMH and NiCd battery. The valid value ranges from 5 to 20 mV per cell.
Setting the trigger voltage higher brings a danger of overcharging;
whereas setting it lower brings a possibility of premature termination.
Please refer to the technical specification of the battery.(NiCd
default:12mV, NiMH default:7mV)
The screen shows the nominal voltage of Lithium battery. There are
three kinds of Lithium battery: LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V). This
information is of critical importance that you have to check the battery
carefully to make sure it is set up correctly. If it is different from correct
value, explosion can occur during charge process.
- -
+ +
WARNING AND SAFETY NOTES
14
INC INC
DEC DEC
NiCd Sensitivity
D.Peak Default U S B / T e m p S e l e c t
U S B E n a b l e d