Imagine communications OP+OER+HI+S, Инструкция по установке и эксплуатации

Страница: 46 / 51

32 OP
+
OER Installation and Operation Manual
Copyright © 2010, Harris Corporation
Appendix B: Communication and Control Troubleshooting Tips
b. Unscrew and remove the back module.
c. Inspect the 20- or 30-pin spring connector at the bottom of the
back module (
Figure B-1 on page 32 ), and verify that the
connector does not have any slightly bent or pressed pins.
d. Carefully reposition any bent pins; If this is not possible,
contact Customer Support.
Figure B-1. Typical Back Module Spring Connector
The frame is powered up, but
+
Pilot Lite does not
communicate with the module.
Solutions
• Ensure you have installed the correct cables between the PC and the
frame:
• A null modem serial cable must be used between a PC and an
FR6802
+
frame (not a straight-through cable). At minimum,
this requires that pins 2 and 3 are crossed, but pin 5 (ground) is
straight-through to pin 5 .
• A USB cable must be used between a PC and an FR6802
+
QXF
frame.
• Verify whether you need an ICE6800
+
or 6800
+
ETH module
installed in the frame.